I think anyone would be irritated when people constantly ask things that are already made clear in the OP. I tend to think that the latter is much more likely. Or may I suggest, the more likely problem is that there really is something wrong and it's stuck at 405mhz. Unless of course, you believe that GPU-Z read all those numbers wrong, at the same time, and they happen to match up with each other (temperature with tdp and frequency). Voltage at 0.89v again, obviously not a full load voltage. TDP is also labeled as 34%, obviously, not running at full speed. Temperature is 33 degrees, unless you think I'm using some kind of a phase-change system, that's clearly not a possible temperature for a 250w GPU running at maximum frequency.
I'm an idiot and didn't think to actually give it utilization even when it clearly says that there's not enough utilization.īesides, the screenshot I provided shows 100% GPU utilization, AND it shows that there are no thermal issues.Īs for the possibility of a detection error, it too, can be seen in the screenshot. I don't know the meaning of the word "utilization", AND I never looked it upĢ. Knowing that, and still questioning if I actually did stress the GPU implies only one of two possible things:ġ. In my OP post I clearly stated that GPU-Z reports a performance cap reason as "utilization", which obviously means that I am aware of this fact. I'm sorry it came through like that, but please take a close look and see if you'll also get irritated by the same situation.
0 kommentar(er)
